Taking Steps – an FtM Transition Blog

Just another WordPress.com weblog

Part Two of the STP Saga!

leave a comment »

So, I shall presume that you all know what an STP is by now, and talk from that standpoint!

The pictures in the gallery below should show you the process that I used to do this, but since I can’t work out how to put them individually, you’ll have to browse.

How to bake a STP

Ingredients

One Packer

One metre of 5mm diameter tubing (bought in a medium size Robert Dyas for about £2)

One teat for a baby bottle (bought in a medium size Boots for about £2)

One reel of duct/gaffa tape (bought in a small Robert Dyas for about £6)

Materials

One skewer (not corkscrew) as used for barbequing

Alternatively one long tent peg

One stove (gas was used)

One cold water tap

One pair of scissors

One marker pen

One stopwatch

Method

  1. Put the kettle on and lay out cups of tea
  2. Take the marker pen and mark on the tip of the penis and back of the ballsack the rough line you wish the hole to pass through
  3. Pour the hot water over the teabags
  4. Heat the skewer or tent peg over the stove on high heat for a minute. Be sure to leave a part of it far enough away from the heat to be grasped. Use the stopwatch to time this
  5. Hold the packer securely and slip the red-hot metal through it, from tip down shaft and out ballsack. It goes very fast if you are not careful, and melts very very easily, so go as slowly as you need to to ensure the line you have is at least roughly the line you wished to have
  6. Rush to a tap  and remove the skewer, pulling the edges of the holes apart, thrusting your hands into the packer down the hole, and turning it inside out if necessary to ensure that the hole goes right through smoothly. Leave it in cold water for 1-2 minutes
  7. Take the teabags out, add milk and sugar to taste and start drinking
  8. Wash up the skewer, turn the stove off
  9. Take the tubing and the teat. Cut the end off the teat in a very small way, and feed the tube into this. Use the duct or gaffa tape to secure this very securely. It comes off otherwise, and the tape struggles to stick to the smooth rubber of the teat so use LOTS
  10. Feed the tubing from the other end down the cock, leaving a tiny bit sticking out at the tip end, and enough at the ball end to bend it down and have the cup hanging lower than the bottom of the balls
  11. Trim to taste
  12. Rush to the toilet having drunken so much tea, and test it out

Yes, this method does work contrary to my first post where it very very clearly failed. The timings should also make a perfect cup of tea. Try the packer for the first time naked in the shower (you will drip) and get very used to using it without clothes before you add clothes. After that get very used to using it with clothes before you start using it in public!

I will include instructions for a couple of types of harness tomorrow, probably, and the day after will try and write something about how and when to use or not use this marvellous device!

Advertisements

Written by trannyfag

May 20, 2009 at 9:53 am

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: